Lenze ETC Motion Control - Manual (Page 312)

ETC−MMI
"Diagnostics" operating mode
7
7.7
l
312 EDSTCXN EN 2.0
7.7 "Diagnostics" operating mode
The "Diagnostics" operating mode is primarily intended for service and
commissioning technicians.
It offers functions for the support of axis setting, for the control of
inputs/outputs and parameters, for editing machine constants and for the
control of internal statuses.
In addition, the error logbook, which logs all errors, can be accessed.
ETCN083
Axis setting... Activate displays for support during axis setting. The
handling corresponds to the SETUP operating mode.
Modal travel The axis selected with the <Axis> key (or <Cursor> keys)
is traversed as long as the <Travel +>/<Travel −> key is
pressed. The speed at which the axes are traversed is
determined by MK_MODVMAX. It can be influenced via
the <Override +>/<Override −> key.
Drag/Mod/Nom p. Switch−over of the display between:
l Tolerance margin in input unit [mm]
l Set position
l Modal position
Input Enter single block (e.g. G, S, T and M functions). The
execution is completed and triggered with <Enter>.
back... Back to the previous level.
Horizontal function keys