MTS Criterion 60 - Manual - Manual (Page 64)

MTS Criterion™ Series 60 Product Manual 64
Controller Connections
Installation
Installing Cables
To maintain EMC compliance and help ensure optimal performance, MTS
recommends ordering all system cables from MTS. Cables should be installed so
that they are protected from conditions that could damage the cable.
Exercise care when connecting cables. Ensure that you use the correct cables and
that all connections are secure. When you are finished, double-check to ensure
that all components are connected properly.
Check the power before connecting cables.
Connecting cables with power applied may cause injury to personnel or
damage to the equipment.
Ensure that the power is off before connecting cables.
Controller Connectors
J1 USB
This is a standard USB 2.0 connector that accepts a USB-B cable connector and
connects the computer. This provides a communications interface between the
testing software on the PC and the controller. This is used to allow the software to
change settings in the controller and receive data from the controller.
CAUTION