SATEC RDM172 Manual - Manual (Page 102)

Chapter 4 PAS Application Software Administration
102 Series PM172 Powermeters
To reset the desired accumulation registers or to clear a file:
1. Click on the corresponding button, and then confirm your command.
2. If a target has more than one component, you are allowed to select
components to reset.
3. Check the corresponding boxes, and then click OK.
Administration
Changing a Password
PAS allows you to remotely change the password, and enable or disable the
password security check in your meter. To change the password, check the
On-line button, select Administration from the Monitor menu, and then select
Change Password.
To change the password:
1. Type in a new 4-digit password
2. Repeat the password in the Confirm box
3. Check the “Enable network protection” to enable password checking
4. Click
Send.
Upgrading Device Firmware
Your meter has upgradeable firmware. If you need to upgrade your device,
download a new firmware file to the meter through PAS.
Firmware is downloaded through any communication port except the
Profibus port. The meter may be connected to your PC through a serial
interface, a dial-up modem or the Internet.