SATEC RDM172 Manual - Manual (Page 26)

Chapter 2 Installation Communications Connections
26 Series PM172 Powermeters
Communications Connections
Several communication options are available for the PM172:
COM1 (check the label on the back of your meter):
RS-232/RS-422/RS-485
56K Dial-up modem
Ethernet 10/100BaseT
Profibus DP
COM2:
RS-422/RS-485
The RS-232/RS-422/RS-485 port is a standard port for COM1. Other options
are ordered separately. Connections to the Ethernet RJ45 connector and to
the telephone RJ11 connector are made through a cable adaptor provided
with your meter (if ordered).
A full description of the communication protocols is found in the PM172
protocol guides provided with your meter.
COM1 RS-232 Connection
0-1mA
0-20mA
V
-+1mA LOW DC
N
(24) 18-36VDC
(48) 36-72VDC S
2 (12) 10-16VDC
+ 7
3
9 6
5 1
- 4-20mA 9 8
COM.1 :
ATTENTION
Devices
Static-Sensitive
Static-Safe
Workstations
Handle Only at
POWER SUPPLY
RS-422/RS-485
16
+RX
COM.2 COM.1
11
V
15 13 14
6 9 N
1 5
-TX +TX -RX
V
MODEM
PROFIBUS
ETHERNET
RS-232/422/485 STANDARD
3
17
12 L/+
N/- 10
ANALOG IN/OUT :
Connector 9-pin D-type female:
Pin Signal
1 RS-232 RTS
2 RS-232 RxD
3 RS-232 TxD
4 RS-232 CTS
5 RS-232 Signal ground
PM172
RS
- 232
MALE CON.
PM172
RS-232
MALE CON.