Rockwell Automation 20D PowerFlex 700S Phase II Drive Frames 1...6 Installation Instructions - Manual (Page 37)

Rockwell Automation Publication 20D-IN024C-EN-P - July 2013 37
PowerFlex 700S Adjustable Frequency AC Drive - Phase II Control
Accessing the Terminals
Figure 13 - Opening the Drive Cover
(x2)
(x3)
=
BR1 BR2 DC+ DC- PE
U/T1 V/T2 W/T3 R/L1 L2
(x2) Proper tightening torque for
reassembly is 0.7 N•m (6 lb•in)
Removing the Cassette
Task Description
Open the door of the power structure and disconnect the cables that
connect to the main board. Depress the locking tab on connector
before disconnecting cables.
Loosen the screws on the face of the cassette.
Remove the cassette.
A
B
C
Removing the Side Covers
Task Description
Loosen the screws on the face of the front cover and remove the cover.
Loosen the screws on the side of rear cover and remove the cover.
A
B
Frames 1…4
Locate the slot in the upper left corner. Slide the locking
tab up and swing the cover open. Special hinges allow
the cover to move away from the drive and lay on top of
an adjacent drive (if present).
Frame 5
Slide the locking tab up, loosen the right-hand cover
screw and remove the cover.
Frame 6
Loosen the two screws at the bottom of the bottom
cover and carefully slide the cover down and out.
Loosen the two screws at top of the top cover and
remove the cover.
A
B
C
A
B