Stegmann hi-resolution encoder feedback option – Rockwell Automation 20D PowerFlex 700S Phase II Drive Frames 1...6 Installation Instructions User Manual

Page 64

Advertising
background image

64

Rockwell Automation Publication 20D-IN024C-EN-P - July 2013

PowerFlex 700S Adjustable Frequency AC Drive - Phase II Control

Stegmann Hi-Resolution Encoder Feedback Option

Stegmann Hi-Resolution Encoder Feedback Option Specifications

Encoders Supported by the Stegmann Hi-Resolution Encoder Feedback Option
Card

Hiperface® SINCOS

®

, SINCODER

®

and LINCODER

®

are registered trademarks of Stegmann Inc.

Consideration

Description

Encoder Voltage Supply

11.5V DC @ 130 mA

Hi-Resolution Feedback

Sine/Cosine 1V P-P Offset 2.5

Maximum Cable Length

90 m (295 ft)

Maximum Frequency
(Encoder Speed)

12.5

μs/cycle

(4687.5 rpm for encoders with 1024 sine cycles per revolution)
(9375 rpm for encoders with 512 sine cycles per revolution)

RS-485 Interface

The Hi-Resolution Feedback Option card obtains the following information via the
Hiperface RS-485 interface shortly after powerup:
Address
Command Number
Mode
Number of turns
Number of Sine/Cos cycles
Checksum

IMPORTANT

Please note that encoders must be ordered as “Single Ended” so that the RS-
485 channel has the proper termination network installed at the factory.

Hi-Resolution Encoder Model

Resolution

Comment

Stegmann SINCOS SCS-60, SCS-70,
SCM-60, and SCM-70

512 sine cycles per revolution.

SCM-60 and SCM-70 have built-in
mechanical turns counter.

Stegmann SINCOS SCS-KIT-101
and SCM-KIT-101

1024 sine cycles per revolution.

SCM-60 and SCM-70 have built-in
mechanical turns counter.

Stegmann SINCOS SRS-50, SRS-60,
SRM-50, and SRM-60

1024 sine cycles per revolution.

SRM-50 and SRM-60 have built-in
mechanical turns counter.

Stegmann SINCOS SRS/SRM 25

1024 sine cycles per revolution

SRS25 and SRM25 have built-in mechanical
turns counter. IP65 Protection Class. Size 25
square flange mounting.

Stegmann SINCOS SRS660

1024 sine cycles per revolution

Hollow-shaft up to 14 mm diameter

Stegmann SINCOS SHS-170

512 sine cycles per revolution.

While the software supports this encoder,
the SHS-170 draws excessive current and
should only be used with an external power
supply.

Allen-Bradley 842HR

1024 sine cycles per revolution

Has built-in mechanical turns counter. IP65
Protection Class. Size 25 square flange
mounting.

Advertising
This manual is related to the following products: