User-supplied equipment – Rockwell Automation 20-750-PBUS Profibus DPV1 Option Module User Manual
Page 14
14
Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012
Chapter 1 Getting Started
User-Supplied Equipment
To install and configure the option module, you must supply the following:
❑ A small screwdriver
❑ Profibus cable; only use cable that conforms to Profibus cable standards
(Belden #3079A Profibus cable or equivalent is recommended)
❑ One 9-pin, male D-Sub Profibus connector
Profibus connectors are available from a variety of sources and in various
sizes. As such, there may be mechanical limitations that prohibit the use of
some connectors. Phoenix SUBCON-PLUS-PROFIB/AX/SC (Part #
2744380), Siemens 6GK1500-0FC00, or Brad BM5G60PP4Mxxx are
recommended for use with PowerFlex 750 drives.
❑ Configuration tool, such as the following:
– PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM
– Connected Components Workbench software, version 1.02 or later
Connected Components Workbench is the recommended stand-alone
software tool for use with PowerFlex drives. You can obtain a free copy
by:
•
Internet download at
•
Requesting a DVD at
Your local distributor may also have copies of the DVD available.
Connected Components Workbench software cannot be used to
configure SCANport-based drives or Bulletin 160 drives.
– DriveExplorer software, version 6.01 or later
This software tool has been discontinued and is now available as
freeware
at
. There are no plans to provide future updates to this tool
and the download is being provided ‘as-is’ for users that lost their
DriveExplorer CD, or need to configure legacy products not supported
by Connected Components Workbench software.