Rockwell Automation 20-750-PBUS Profibus DPV1 Option Module - Manual (Page 25)

Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012 25
Installing the Option Module Chapter 2
Applying Power
Apply power to the drive. The option module receives its power from the drive.
When you apply power to the option module for the first time, its topmost
PORT status indicator should be steady green or flashing green after
initialization. If it is red, there is a problem. See
Chapter 7 , Troubleshooting .
Start-Up Status Indications
The drive STS (status) indicator can be viewed on front of the drive after power
has been applied. The option module status indicators can be viewed with the
drive cover open or removed (
Figure 5 ).
Figure 5 - Drive and Option Module Status Indicators
ATTENTION: Risk of equipment damage, injury, or death exists.
Unpredictable operation may occur if you fail to verify that parameter
settings are compatible with your application. Verify that settings are
compatible with your application before applying power to the drive.
➊
➋
➌
➍
Drive Control Pod
See Table 2 for
possible start-up
status indications