Rockwell Automation 20-750-PBUS Profibus DPV1 Option Module - Manual (Page 71)

Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012 71
Troubleshooting Chapter 7
14 DPI Baud 500kbps The option module detected that the drive was communicating at 500 Kbps.
15 DPI Host Invalid The option module was connected to an incompatible product.
16 DPI Dup Port Another peripheral with the same port number is already in use.
17 DPI Type 0 Logon The option module has logged in for Type 0 control.
18 DPI Type 0 Time The option module has not received a Type 0 status message within the specified time.
19 DPI DL Logon The option module has logged into a Datalink.
20 DPI DL Error The drive rejected an attempt to log in to a Datalink because the Datalink is not supported or is used by another
peripheral.
21 DPI DL Time The option module has not received a Datalink message within the specified time.
22 DPI Ctrl Disable The option module has sent a ‘Soft Control Disable’ command to the drive.
23 DPI Ctrl Enable The option module has sent a ‘Soft Control Enable’ command to the drive.
24 DPI Msg Timeout A Client-Server message sent by the option module was not completed within 1 second.
25 DPI Manual Reset The option module was reset by changing its Reset Module parameter.
SI Events
26 SI Online The option module has logged into the Serial Interface Communications.
27 SI Logon Error The option module failed to log into the Serial Interface.
28 SI Comm Fault The Serial Interface Communications has faulted.
Network Events
29 Net Link Up A network link was available for the Option Module.
30 Net Link Down The network link was removed from the Option Module.
31 Net Dup Address The option module uses the same address as another device on the network.
32 Net Comm Fault The option module detected a communications fault on the network.
33 Net Sent Reset The option module received a reset from the network.
34 Net IO Close An I/O connection from the network to the option module was closed.
35 Net Idle Fault The option module detected an idle fault condition on the network (Master in programming mode or slave
parameterization in progress).
36 Net IO Open An I/O connection from the network to the option module has been opened.
37 Net IO Timeout An I/O connection from the network to the option module has timed out.
38 Net IO Size Err The option module received an incorrectly sized I/O packet.
39-56 Reserved —
57 Option Card Flt Internal option module faults.
58 Module Defaulted The option module has been set to defaults.
59 Net Freeze Freeze command has been issued by the Profibus master for this option module.
60 Net Unfreeze Unfreeze command has been issued by the Profibus master for this option module.
61 Net Sync Sync command has been issued by the Profibus master for this option module.
62 Net Unsync Unsync command has been issued by the Profibus master for this option module.
63 Net Clear Cmd The option module received a Profibus ‘Clear Command’ from the network master.
64 Net Set Prm The option module received a Profibus ‘Set Parameters’ command from the network master.
65 Net WD Timeout The Profibus ASIC has declared a network timeout.
Table 7 - Option Module Events (Continued)
Code Event Text Description