Rockwell Automation 20-750-PBUS Profibus DPV1 Option Module - Manual (Page 29)

Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012 29
Chapter
3
Configuring the Option Module
This chapter provides instructions and information for setting the parameters to
configure the option module.
For a list of parameters, see Appendix B , Option Module Parameters. For
definitions of terms in this chapter, see the Glossary .
Configuration Tools The option module stores parameters and other information in its own
nonvolatile storage (NVS) memory. You must, therefore, access the option
module to view and edit its parameters. The following tools can be used to access
the option module parameters.
Topic Page
Configuration Tools 29
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM to Access Parameters 30
Setting the Node Address 30
Setting a Master-Slave Hierarchy (Optional) 30
Setting a Fault Action 33
Resetting the Option Module 34
Restoring Option Module Parameters to Factory Defaults 35
Viewing the Option Module Status Using Parameters 36
Updating the Option Module Firmware 37
Tool See
PowerFlex 20-HIM-A6 or 20-HIM-C6S HIM page 30
Connected Components Workbench software,
version 1.02 or later http://www.ab.rockwellautomation.com/Drives/
Software/9328-ConnectedComponentsWorkbench
,
or online help (installed with the software)
DriveExplorer software, version 6.01or later http://www.ab.com/drives/driveexplorer , or online
help (installed with the software)
DriveExecutive software, version 5.01 or later http://www.ab.com/drives/drivetools , or online help
(installed with the software)
IMPORTANT For the HIM screens shown throughout this chapter, the option module
was installed in drive Port 4. If your option module is installed in a
different drive port, that port would appear instead of Port 4.