Rockwell Automation 20-750-PBUS Profibus DPV1 Option Module - Manual (Page 35)

Rockwell Automation Publication 750COM-UM004B-EN-P - September 2012 35
Configuring the Option Module Chapter 3
Restoring Option Module
Parameters to Factory
Defaults As an alternate reset method, you can restore the option module parameters using
a MEMORY folder menu item instead of using
Device Parameter 07 - [Reset
Module] described in Resetting the Option Module on page 34 . The MEMORY
folder method provides two ways to restore the option module Device and Host
parameters:
• ALL—Restores ALL option module Device and Host parameters to their
factory default values.
• MOST—Restores MOST option module Device and Host parameters—
except Device Parameter 05 - [Net Addr Cfg] which is used for network
setup.
Follow these steps to restore option module Device and Host parameters to their
factory default values.
1. Access the Status screen, which is displayed on HIM power up.
2. Use the or key to scroll to the Port in which the option
module is installed.
3. Press the key to display its last-viewed folder.
4. Use the or key to scroll to the MEMORY folder.
5. Use the or key to select Set Defaults.
6. Press the (Enter) key to display the Set Defaults pop-up box.
7. Press the (Enter) key again to display the warning pop-up box to
reset Device and Host parameters to their factory default values.
IMPORTANT When performing a Set Defaults, the drive may detect a conflict and then
not allow this function to occur. If this happens, first resolve the conflict
and then repeat Set Defaults action. Common reasons for a conflict
include the drive running or a controller in Run mode.
TIP If your application allows, you can also reset the option module by
cycling power to the drive (resetting the drive) or by using the HIM’s
Reset Device function located in the drive’s DIAGNOSTIC folder.
00
Stopped
0.00 Hz
AUTO
Host Drive
240V 4.2A
Rev 3.002 Ser. A
ESC REF TEXT
F
PAR#