Rockwell Automation 25-COMM-P PowerFlex PROFIBUS DPV1 Adapter - Manual (Page 23)

Rockwell Automation Publication 520COM-UM004A-EN-E - November 2013 23
Chapter
3
Configuring the Adapter
This chapter provides instructions and information for setting the parameters to
configure the adapter.
For a list of parameters, see Adapter Parameters on page 77 . For definitions of
terms in this chapter, see the Glossary on page 85 .
Configuration Tools The adapter parameters can be configured using the drive keypad interface (see
page 23 ) or a PowerFlex 4-class HIM (Human Interface Module, see page 25 ).
Connected Components Workbench (version 3 or greater) can also be used to
access the adapter parameters.
Using the Drive Keypad
Interface to Access
Parameters The following is an example of basic integral keypad and display functions. This
example provides basic navigation instructions and illustrates how to program a
parameter.
Topic Page
Configuration Tools 23
Using the Drive Keypad Interface to Access Parameters 23
Using the PowerFlex 4-Class HIM to Access Parameters 25
Setting the Node Address 25
Using Master-Slave Hierarchy (Optional) 26
Setting a Fault Action 27
Resetting the Adapter 28
Restoring Adapter Parameters to Factory Defaults 29
Viewing the Adapter Status Using Parameters 29
Updating the Adapter Firmware 29
IMPORTANT The adapter Device parameters can be accessed on the drive keypad via the “N”
(Network) group. Note that the parameters in the “N” group will appear offset
from the Device parameter numbers referenced in this manual by 1000
(decimal) on the LCD display.