Rockwell Automation 25-COMM-P PowerFlex PROFIBUS DPV1 Adapter - Manual (Page 38)

38 Rockwell Automation Publication 520COM-UM004A-EN-E - November 2013
Chapter 4 Configuring the PROFIBUS Master
5. Double-click the Slave icon to view the Slave Properties, or right-click the
slave icon and select Object Properties.
The PCB software automatically assigns a PROFIBUS address to each
new slave. The address assignment begins at address 3, and is incremented
by 1 for each new slave added to the network.
6. You can change the address in the Common tab of the Slave properties
dialog box.
The address should match the PowerFlex 520-series drive’s PROFIBUS
address assigned for the specific drive you are configuring. The PCB
software will not allow you to assign a PROFIBUS address that is already
in use by another module on this network.