Rockwell Automation 440R Guardmaster EtherNet/IP Network Interface User Manual - Manual (Page 14)

14 Rockwell Automation Publication 440R-UM009B-EN-P - February 2014
Chapter 2 Install a Guardmaster EtherNet/IP Network Interface
Installation Summary Do these steps to install a network interface.
1. Mount the Interface on a DIN Rail.
2. Install the Interface.
ATTENTION: Prevent Electrostatic Discharge
This equipment is sensitive to electrostatic discharge, which can cause
internal damage and affect normal operation.
Follow these guidelines when you handle this equipment:
• Touch a grounded object to discharge potential static
• Wear an approved grounding wrist strap
• Do not touch connectors or pins on component boards
• Do not touch circuit components inside the equipment
• Use a static-safe workstation, if available
• Store the equipment in appropriate static-safe packaging when not in use
SHOCK HAZARD: To prevent electrical shock, disconnect the EtherNet/IP
network interface from it power source before installing or servicing. Install in
suitable enclosure. Keep free from contaminants.
ATTENTION: An incorrectly applied or installed EtherNet/IP network
interface can result in damage to the components or reduction in product
life. Wiring or application errors (e.g. supplying incorrect or inadequate
supply voltage or operating/storing in excessive ambient temperatures) may
result in malfunction of the product.
ATTENTION: Only personnel familiar with the EtherNet/IP network interface
and associated machinery should plan to install, set up, and maintain the
system. Failure to comply may result in personal injury and/or equipment
damage.
ATTENTION: This is a Class A product. In a domestic environment, this
product may cause radio interference in which case the user may be required
to take adequate measures.