Rockwell Automation 440R Guardmaster EtherNet/IP Network Interface User Manual - Manual (Page 15)

Rockwell Automation Publication 440R-UM009B-EN-P - February 2014 15
Install a Guardmaster EtherNet/IP Network Interface Chapter 2
Use the figure to identify the external features of your interface.
Figure 1 - Physical Features of the 440R-ENETR Interface
Mount the Interface on a DIN
Rail Follow these steps to mount the interface on a DIN Rail.
1. Position the adapter vertically above an IEC standard (35x7.5x1 mm) top-
hat DIN Rail at a slight angle (DIN Rail: Cat. No. 199-DR1; 46277-3).
2. Press down firmly to install the interface on the DIN Rail.
3. Set the network address switches to the desired value. See Set the Network
Address in chapter 3 for more details on setting the IP address.
To remove your interface from the DIN Rail, pry the DIN Rail latch downwards
until there is separation from the latch and the DIN Rail.
Description Description
1 Removable terminal block 4 Network address rotary switches
2 Status indicators 5 Ethernet network RJ-45 connectors
3 Optical communications link
5
1
2
3
4
ATTENTION: To avoid overheating, the unit must be mounted vertically and
requires 37.4 mm (1.5 in.) of clearance at the top and the bottom to allow
adequate ventilation. The temperature ratings for the unit will be derated if
not mounted in this manner.