Rockwell Automation 440R Guardmaster EtherNet/IP Network Interface User Manual - Manual (Page 24)

24 Rockwell Automation Publication 440R-UM009B-EN-P - February 2014
Chapter 3 Configure the Interface for Your EtherNet/IP Network
Use the Rockwell BootP/
DHCP Utility The Rockwell BootP/DHCP utility is a standalone program that incorporates
the functionality of standard BootP software with a user friendly graphical
interface. It is located in the Utils directory on the RSLogix5000 software
installation CD. The interface must have DHCP enabled (factory default and
the network address switches set to an invalid value) to use the utility.
To configure your interface using the BootP utility, perform the following steps:
1. Run the BootP software.
In the BOOTP Request History panel you see the hardware addresses of
devices issuing BootP requests.