Rockwell Automation 1783-EMS08T Stratix 6000 Ethernet Managed Switch User Manual - Manual (Page 23)

Rockwell Automation Publication 1783-UM001D-EN-P - January 2013 23
Network Services Setup Chapter 2
ip.ipNetToMediaTable.ipNetToMediaEntry.ipNetToMediaIfIndex
ip.ipNetToMediaTable.ipNetToMediaEntry.ipNetToMediaPhysAddress
ip.ipNetToMediaTable.ipNetToMediaEntry.ipNetToMediaIpAddress
ip.ipNetToMediaTable.ipNetToMediaEntry.ipNetToMediaType
(A static entry cannot be added into the ARP cache table)
tcp.tcpConnTable.tcpConnEntry.tcpConnState
(An established or pending TCP connection cannot be reset)
SNMP Configuration
Enable SNMP if you want to run SNMP on your network. SNMP is disabled by
default.
Before configuring SNMP settings, understand these concepts:
• Community names—Community names are passwords to the switch
Management Information Base (MIB) that allow a remote manager read-
only or read-write access to the switch. The Stratix 6000 switch supports
one read-only community name and one read-write community name.
You can change the default names.
• SNMP traps—SNMP traps are unsoliticited messages sent to a remote
manager from an agent. Traps are an efficient way to inform managers that
are connected to a large number of devices with many objects. By
providing unsolicited messaging, traps can reduce SNMP polling by a
manager. The Stratix 6000 switch supports two destination traps that can
be enabled or disabled. By default, both traps are disabled.
Use these steps to configure SNMP.
1. From the navigation pane, expand the Network Services Setup folder and
select SNMP Configuration.