Rockwell Automation 1783-EMS08T Stratix 6000 Ethernet Managed Switch User Manual - Manual (Page 85)

Rockwell Automation Publication 1783-UM001D-EN-P - January 2013 85
Add the Switch to Software Appendix E
Configure Bandwidth and MAC ID Management Alarming
From the Module Properties dialog box, click the Alarms tab to display this
information:
• Bandwidth Alarm area
– Used to configure bandwidth alarming and displays a graph of current
network traffic. The bars are red if the port is in alarm and green if it is
not.
– The bandwidth alarm requires a point of comparison. This must be set
in the HTML interface.
• MAC ID Management
– Used to configure MAC ID management alarming and displays the
alarm status on each port.
– Click Set to load settings from this tab into the 1783-EMS switch.
– Click Refresh to populates this tab with settings from the 1783-EMS
switch.
Configure Port Behavior for Fault and Idle States
From the Module Properties dialog box, click the Fault/Idle State tab to
configure port behavior when the switch loses communication with the Logix
IMPORTANT Unlike IGMP, bandwidth alarming can be enabled from here or from
the HTML interface.
IMPORTANT Unlike IGMP, MAC ID management alarming can be enabled from here
or from the HTML interface.