Rockwell Automation 1769-OF4VI Compact I/O Isolated Analog Modules - Manual (Page 60)

Publication 1769-UM014B-EN-P - May 2010
4-8 Module Data, Status, and Channel Configuration for the Output Modules
1769-OF4CI and -OF4VI Channel Configuration
The first two words of each eight word group in the configuration file allow
you to change the parameters of each channel independently. For example,
words 8 and 9 correspond to channel 1 while words 24 and 25 correspond to
channel 3.
Table 4.6 1769-OF4CI and -OF4VI Channel Configuration Word 0 (1)
Define Indicate Bit Settings
15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Program (Idle) to
Fault Enable
Program (Idle)
Mode Data
Applied
(2)
0
Fault Mode
Data Applied
(2)
1
Hold for
Initialization
Disabled 0
Enabled 1
Program (Idle)
Mode
Hold Last
State
(2)
0
User-Defined
Value
(2)
1
Fault Mode Hold Last
State
(2)
0
User-Defined
Fault Value
(2)
1
Enable Ramping Disabled 0
Enabled (2) 1
Enable Clamp/
Alarm Latching
Disabled 0
Enabled 1
Enable High
Clamp/ Alarm
Interrupt
Disabled 0
Enabled (2) 1
Enable Low
Clamp/ Alarm
Interrupt
Disabled 0
Enabled (2) 1
Enable Channel Disabled 0
Enabled 1
(1) Refer to the 1769-OF4CI and -OF4VI Output Channel Configuration Word 1 table.
(2) Hold Last State and User Defined Fault functionality is only supported when the analog module is used in a DeviceNet
application via the 1769-ADN adapter No local configuration, that is, a MicroLogix or CompactLogix system, supports this
functionality. Refer to your controller manual for details.