Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 14)

Setting Up Your Equipment
1–9
Installing the Software
Before installing the software, make sure your personal computer meets the memory
and RAM requirements needed to run APS. Refer to the Advanced Programming
Software User Manual for more detailed information on personal computer
requirements and APS software installation.
Locating the Software’s Serial Number
During the installation process you are asked for the serial number of your software.
The serial number you enter is used to personalize the software.
The serial number is not found on the disks. It can be found in several places
though. These are:
•
the software registration card
•
the registration change card
•
the outside of the shipping carton
Note If you enter the serial number incorrectly or enter the wrong serial number and
accept the entry, you will be unable to correct this situation later. Therefore, verify
your serial number carefully, before committing your work.
Installing the Software
To install the software, do the following:
1. Insert the diskette labeled Disk 1 into the appropriate disk drive (either drive A
or drive B). For this example, we are using drive A.
2. Type: A:INSTALL , then press [ENTER] .
3. During the installation process, instructions appear on the screen to prompt you
through the procedure. Follow the instructions and type in the information
requested.
Note You can install APS to run in a windows environment, however, that procedure is
beyond the scope of this manual. See the Advanced Programming Software User
Manual for this information.