Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 59)

Preface
APS Quick Start for New Users
A–2
Entering an Input and Output Branch
The important feature of this program is the output and input branch. The input
branch is based on what is called OR or parallel logic. This means that if either
input #0 OR input #1 is true, then output #0 and #1 turn on.
Exercise 1: Entering an Input and Output Branch
We are assuming you have created a new file, configured it and you are now ready
to begin entering an instruction. See chapter 3 for help with the above. Begin
offline at the edit screen.
1. Enter the rung and XIC instruction.
Press
CONFIG OFFLINE
CONFIG
INSERT
RUNG
F4
, then
CONFIG OFFLINE
CONFIG
INSERT
INSTR
F4
, then
CONFIG OFFLINE
CONFIG
BIT
F1
, then
CONFIG OFFLINE
CONFIG
XIC
-] [-
F1
. Type the
address I:1/0 then press [ENTER] , then [ESC] .
] [
I:1
0
] [
I:1
1
2. Enter a branch and another XIC instruction.
Cursor left once, so your cursor is on the XIC instruction. Press
CONFIG OFFLINE
CONFIG
BRANCH
F1
,
then
CONFIG OFFLINE
CONFIG
INSERT
BRANCH
F4
, then
CONFIG OFFLINE
CONFIG
TARGET
F2
B , then
CONFIG OFFLINE
CONFIG
INSERT
INSTR
F4
,
then
CONFIG OFFLINE
CONFIG
BIT
F1
, then
CONFIG OFFLINE
CONFIG
XIC
-] [-
F1
.