Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 45)

Online Operations, Quick Edit
4–5
When the restoring (downloading) process is complete, you are asked to “Press
Any Key to Continue”. After you press any key, the program directory for file
GETSTART appears:
FILE NAME TYPE SIZE (words)
0 system 72
1 reserved 0
2 ladder 3
Press a key, enter file number or file name
REM PROG SLC 5/02 Series C FRN 5 PROC Addr 1
PROGRAM DIRECTORY FOR PROCESSOR: GETSTART
F1 F2 F6 F7 F3 F4 F8
PROCSSR
FUNCTNS
SAVE
RESTORE
CREATE
REPORTS
FILE
OPTIONS
RETURN
TO MENU
CHANGE
LNK ADR
MONITOR
FILE
F5
WHO
ACTIVE
F9 F10
DATA
MONITOR
MEMORY
MAP
Testing the Program
To test the ladder program you entered in chapter 3, we will now monitor program
file 2, and change the processor mode from program to run. Then activate the
external input having address I:1/0 and observe the effect on the external output at
address O:3/0.
Begin at the program directory display for processor file GETSTART.
1. Monitor program file 2 and enter the Run mode.
Press
CONFIG OFFLINE
CONFIG
MONITOR
FILE
F8
. The ladder program appears.
Press
CONFIG OFFLINE
CONFIG
CHANGE
MODE
F1
, then
CONFIG OFFLINE
CONFIG
RUN
MODE
F3
, then
CONFIG OFFLINE
CONFIG
YES
F8
. (Note that the status line
now indicates REM RUN instead of program.) If you get a fault code on the
status line, refer to appendix B to clear the fault.
2. Test the program.