Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 36)

Preface
APS Quick Start for New Users
3–8
6. Configure the I/O modules.
The cursor is located on slot 1. To configure it, press
CONFIG OFFLINE
CONFIG
MODIFY
SLOT
F5
. The
following option window appears:
CATALOG CARD DESCRIPTION
1746-I*8 Any 8pt. Discrete Input Module
1746-I*16 Any 16pt. Discrete Input Module
1746-I*32 Any 32pt. Discrete Input Module
1746-O*8 Any 8pt. Discrete Output Module
1746-O*16 Any 16pt. Discrete Output Module
1746-O*32 Any 32pt. Discrete Output Module
1746-IA4 4 - Input 100/120 VAC
1746-IA8 8 - Input 100/120 VAC
1746-IA16 16 - Input 100/120 VAC
1746-IB8 8 - Input (SINK) 24 VDC
1746-IB16 16 - Input (SINK) 24 VDC
1746-IB32 32 - Input (SINK) 24 VDC
Press ENTER to select I/O Module
Enter Module ID Code >
I/O MODULE SELECTION FOR SLOT: 1
F2
SELECT
MODULE
ESC exits
This window allows you to select a module for slot 1. Use the up/down cursor
keys to place the cursor on the appropriate module catalog number, then press
CONFIG OFFLINE
CONFIG
SELECT
MODULE
F2
. This returns the display to the I/O configuration window with the
selected module indicated. Cursor down to the next open slot and repeat the
configuration steps.