Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 50)

Preface
APS Quick Start for New Users
4–10
Monitoring Data Files
In this procedure, you will monitor the input data file and the output data file. These
files include a status bit for each of the configured I/O terminals of the controller.
You will monitor data file changes as you operate pushbutton 0 and selector switch
6. To end the exercise, you will go offline to the APS menu.
The starting point is the online monitor file display with the processor in the run
mode:
Press a function key
(file 2, rung 0)
REM RUN no forces PROC Addr 1
F2
CONFIG
DISPLAY
F9
FORCE
END
F10
EDIT
F3
EXIT
F6 F7
SEARCH GENERAL
UTILITY
( )
O:3
0
] [
I:1
0
Input pushbutton turns on output pilot light
F8
DATA
MONITOR
F1
CHANGE
MODE
] [
I:2
2
F5
DOCUMNT
1. Position the ladder cursor and access the input data file.
Use the cursor key to position the cursor on the XIC instruction having address
I:1/0, then press
CONFIG OFFLINE
CONFIG
DATA
MONITOR
F8
. The input data file appears, with the cursor located
on status bit I:1/0. This is shown below.
address 15 data 0 address 15 data 0
I:1
0000
I:2 0000 0000
Press a key or enter value
I:1/0 =
REM RUN no forces binary data decimal addr PROC Addr 1
F7 F5
NEXT
FILE
SPECIFY
ADDRESS
F8
PREV
FIILE
F1
CHANGE
RADIX
F6
FORCE
MONITOR