Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 33)

Creating a Processor File
3–5
Arbitrary Controller Used in this Manual
In the following procedures, we have arbitrarily assumed that the controller you are
configuring in your processor file is a modular demo unit including the following
components:
•
Chassis 1746-A4, 4-slot chassis
•
Processor 1747-L524 in slot 0
•
Input module 1746-IA4 in slot 1
•
Input module 1746-IA8 in slot 2
•
Output module 1746-OA8 in slot 3
The ladder program shown on page 3–10 contains I/O addresses that are consistent
with the configuration indicated above. If you are using some other controller
configuration, keep in mind that these addresses may not be valid for your
controller.
Creating a Processor File
A processor file is always created offline, in the terminal workspace. In creating the
processor file, you will:
•
Name the file and configure the controller.
•
Enter a ladder program.
•
Add a rung comment.
•
Save the processor file to disk.
If you are not already running APS, refer to “Running APS,” page 1–10. The
following procedure begins at the APS menu display.
Name the Processor File and Configure the Controller
Complete the following steps:
1. Access the create processor file window.
Press
CONFIG OFFLINE
CONFIG
OFFLINE
CONFIG
F4
, then
CONFIG OFFLINE
CONFIG
CREATE
FILE
F6
.