Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 29)

Creating a Processor File
3–1
3
Creating a Processor File
In this chapter you create a processor file. The tasks you will perform:
•
For modular controllers: Make a record of the processor module catalog
number, the chassis catalog number(s), the I/O module catalog numbers, and the
slot locations of I/O modules.
•
For fixed controllers: Make a record of the controller catalog number (and I/O
module catalog numbers and slot locations if you are using the 1746-A2
expansion chassis).
•
Run APS software and initiate the creation of a processor file.
•
Name the processor file GETSTART.
•
Enter the controller configuration.
•
Enter a 1-rung ladder program.
•
Add a rung comment.
•
Save the processor file to disk.