Rockwell Automation 9323-PA1E QUICK START GUIDE APS 6.0 - Manual (Page 39)

Creating a Processor File
3–11
5. Enter the Output instruction on the rung.
Press
CONFIG OFFLINE
CONFIG
BIT
F1
, then
CONFIG OFFLINE
CONFIG
OTE
-( )-
F3
. Type the address O:3/0 , then press
[ENTER] .
6. Accept the rung.
Press [ESC] , then
CONFIG OFFLINE
CONFIG
ACCEPT
RUNG
F10
, then [ESC] .
Add a Rung Comment
Complete the following steps to add a rung comment:
1. Configure the display so that rung comments will be visible.
Press
CONFIG OFFLINE
CONFIG
CONFIG
F2
DISPLAY . Make sure [F7] reads
CONFIG OFFLINE
CONFIG
SUPPRSS
F7
RNG COM . If it does not, press
CONFIG OFFLINE
CONFIG
DISPLAY
F7
RNG COM to toggle [F7] , before moving to the next step.
Press
CONFIG OFFLINE
CONFIG
SAVE
F10
CONFIG , then [ESC] . The display is now configured so that rung
comments are visible.
2. Add the rung comment.
Press
CONFIG OFFLINE
CONFIG
DOCUMNT
F5
, then
CONFIG OFFLINE
CONFIG
RUNG
COMMENT
F1
. Type the comment Input pushbutton
turns on output pilot light .
3. Accept and save the comment.
Press
CONFIG OFFLINE
CONFIG
ACCEPT
/EXIT
F8
, then
CONFIG OFFLINE
CONFIG
SAVE
DOCUMNT
F10
, then [ESC] .