Rockwell Automation 2364P Parallel DC Bus Supply Config. - Manual (Page 173)

Publication 2364P-5.01 December 1999
Chapter
15
Installation
The instructions in this chapter will guide you in properly installing
the parallel configuration. The processes include receiving and
installing the unit at the designated site, joining enclosures and
buswork, installing the overhead bus, connecting internal
communications and power wiring, connecting all customer wiring,
and connecting AC input. This chapter includes instructions for
testing the parallel configuration.
After the installation is complete, follow the setup instructions in the
next chapter.
Receiving, Handling, and Installing
the Parallel Configuration Directions for receiving and handling the parallel configurations can
be found in publication 2100-5.5, Receiving, Handling, and Storing
Motor Control Centers–Instructions. Prepare a place suitable for the
units according to the system size and the NEMA type ordered.
After the system is in place, follow the directions in publication
2300-5.1, Bulletin 2300 Family of Drive Systems Hardware–
Installation Manual to join the enclosures and to splice the PE, TE,
DC, and control busbars in the system. Refer to publication S-3062,
FD86N Drive Systems Enclosure Hardware–Installation Manual, if
there are any FD86N enclosures in the system.
Make sure that all circuit breakers in the system are in the off position
at this time.