Rockwell Automation 2364P Parallel DC Bus Supply Config. - Manual (Page 212)

Publication 2364P-5.01 December 1999
B-4 Catalog Numbers and Spare Parts Kits
Spare Parts Kits See publication 2364-6.0 for a listing of spare parts available for your
2364P configuration.
1 The configurations presented are the only standard configurations available. You may not change the
order of any units or individual bays within a configuration.
Footnotes:
2 Each parallel configuration includes a basic capacity control transformer(s) to supply only the parallel
configuration with power. Control power source option(s) allow you to select a higher capacity control
transformer for control bus applications. Control power source option(s) includes a control bus fuse and
the control bus.
3 The line RC suppressor is recommended for installations where the primary of the distribution
transformer is 2300V AC or greater.
4 Power transformer must have a resistive, grounded-wye secondary where the resistance is 150 ohms.
5 You may select up to one option from this group.
6 You must select one option from this group.
7 Units come standard with cloth wire labels. Datab labels offer the added protection of a clear plastic
cover on top of the labels.
8 Customer supplies 115V AC control power and wiring to the duplex receptacle.
9
This term: Refers to:
configuration The entire 2364P, consisting of RGUs, NRUs, and any additional hardware required.
each unit A 2364P is comprised of RGU(s) and/or NRUs. Each RGU/NRU is considered a "unit".
each RGU The entire RGU (comprised of 1, 2, or 3 MCC-sections, based on current capacity).
each NRU The entire NRU (comprised of 1 or 2 MCC-sections, based on current capacity).
10 In all configurations with an NRU (Rx, Sx, Tx, Vx), options specified as once per configuration will be
located in the NRU. In all other configurations (Wx), options specified as once per configuration will be
located in the master RGU.