Rockwell Automation 2364P Parallel DC Bus Supply Config. - Manual (Page 191)

Publication 2364P-5.01 December 1999
Chapter
16
Setting Up the Parallel Configuration
This chapter will guide you through the setup procedures for the
parallel configuration. If you need more information about RGU
parameters, please see publication 2364F-5.01.
Introduction to the
Human Interface Module (HIM) The Human Interface Module (HIM), shown in Figure 16.1, can be
used to program and set up the RGU. The table below shows the
function of the keys.
Figure 16.1
Human Interface Module (HIM)
The parameters and functions are organized into a menu tree. This
menu tree is broken into seven modes, including Startup, EEProm,
Search, Control Status, Password, Display, and Process (see
Figure 16.2).
Escape
Pressing the escape key causes the programming system to go back
one level in the menu tree.
Select
Pressing the select key alternates between the top and bottom lines in
the display.
Increment
Pressing the increment key will increment a displayed value. This key
is also used for scrolling through a lists on the display.
Decrement
Pressing the decrement key will decrement a displayed value. This
key is also used for scrolling through lists on the display.
Enter
Pressing this key causes a parameter entry to be saved to memory.
This key is also used to select items on the display.
ESC SEL
S t a r t u p
C h o o s e M o d e
ESC
SEL