Rockwell Automation 2364P Parallel DC Bus Supply Config. - Manual (Page 184)

Publication 2364P-5.01 December 1999
15-12 Installation
SCANport (RGU Main Control Board)
The RGU main control board has three available ports for SCANport
connections. Port 6 is designed for use with a SCANport interface
board.
Figure 15.11
Customer Connections–SCANport (RGU Main Control Board)
Table 15.A: SCANport Connections (RGU Main Control Board)
RGU Main Control Board
J9 (Port 2)
J10 (Port 1)
J8 (Port 6)
Mounting an optional
communication board
Terminals Description
J8 This port is used for attaching an optional SCANport adapter board onto the RGU main control board (such as a
Remote I/O or DeviceNet communication board). This port is designated as Port 6.
J9, J10 These ports are used for connecting SCANport devices. All three SCANports (1, 2, and 6) can communicate
simultaneously between the RGU main control board and SCANport devices. J10 is designated as Port 1 and J9 is
designated as Port 2.