Rockwell Automation 2711E-ND1 PanelBuilder 1400E Configurator Software Getting Started - Manual (Page 14)

1–2 Introducing PanelBuilder 1400e
Publication 2711E-818 – January 1998
PanelBuilder 1400e
PanelBuilder is the development software package you use to create
and configure control panel application screens. Applications
developed with PanelBuilder software on a personal computer are
downloaded to PanelView terminals where they are run.
Development
Computer PanelBuilder
1400e Software
PanelView Operator Terminals
The following terminals will run PanelBuilder 1400e applications:
•
PanelView 1000e terminals, Series A and later, running Version 3
or later firmware
•
PanelView 1200 Series F and later terminals that have been
enhanced with a PanelView 1200 Enhancement Kit (Catalog
Number 2711E-U1B12C), and are running Version 1 or later
firmware
•
PanelView 1200e terminals, Series A and above, running Version 1
or later firmware
•
PanelView 1400e terminals, Series A and above, running Version 1
or later firmware
Note: All other PanelView 1200 terminals will run only applications
created in PanelBuilder DOS (Catalog Number 2711-ND1) or
PanelBuilder 1200 (Catalog Number 2711-ND1W). They will not
run PanelBuilder 1400e applications.
Note: To communicate over a ControlNet network, you must use a
PanelView 1000e or 1400e terminal that has been upgraded to
include an ISA Card Adapter (Catalog Number 2711E-NA1 or
2711E-NA2) and a 1784-KTCX or 1784-KTCX15 card. Or you can
use the new PanelView 1400e terminals that support ControlNet
communications (Catalog Numbers 2711E-K14C7, 2711E-K14C15,
2711E-T14C7, 2711E-T14C15), or the new PanelView 1000e
terminals that support ControlNet communications (Catalog
Numbers 2711E-K10C7, 2711E-K10C15, 2711E-T10C7,
2711E-T10C15). These terminals are ready to use with your
ControlNet network.
"
"