Rockwell Automation 2711E-ND1 PanelBuilder 1400E Configurator Software Getting Started - Manual (Page 28)

2–7 Setting Up PanelBuilder 1400e
Publication 2711E-818 – January 1998
If you choose to install the File Transfer Utility and you want to
upload or download PanelView files over the PLC networks, you
also need to install RSLinx Lite software, which is provided on
3.5-inch floppy disks. See the documentation provided with
RSLinx Lite for installation procedures.
To install PanelBuilder Version 3:
1. Start Windows 95, or 3.1 or later. If you’re already in Windows,
close all open Windows applications.
2. Insert the CD-ROM in the drive.
The CD-ROM begins to run automatically.
3. If the install does not start automatically and you are running on
Windows 95, choose Run from the Start button, or select
setup.exe from Windows Explorer.
If you are running on Windows 3.1 or later, choose Run from the
File menu. In the Run windows, type:
d:setup
where d is the drive containing the PanelBuilder 1400e
CD-ROM, and press Enter.
4. In the Welcome dialog box, choose Next.
5. If you are installing on Windows 95, the Select Components
dialog box appears. Choose Version 3, and then choose Next.
If you are installing on Windows 3.1 or later, the Select
Components dialog box does not appear. Version 3 is selected
automatically.
6. In the Choose Applications dialog box, choose PanelBuilder as
the application you want to install.
You can choose more than one application to install. Choose File
Transfer Utility for the ability to transfer application files
between a computer and the PanelView terminal. Choose Serial
Firmware Upgrade for the ability to upgrade the firmware on
your PanelView terminals using your computer.
Then choose Next.
Installing PanelBuilder
1400e Version 3 from
CD-ROM on Windows 95
or Windows 3.1 or later