Rockwell Automation 2711E-ND1 PanelBuilder 1400E Configurator Software Getting Started - Manual (Page 33)

2–12 Setting Up PanelBuilder 1400e
Publication 2711E-818 – January 1998
If you want to transfer application files between a computer and
the PanelView terminal, you must install the File Transfer Utility.
For instructions on how to install this utility, see Chapter 2 in the
PanelView 1200/1400e Transfer Utility User Manual. If you
choose to install the File Transfer Utility and you want to upload
or download PanelView files over the PLC networks, you also
need to install RSLinx Lite software, which is provided on
3.5-inch floppy disks. See the documentation provided with
RSLinx Lite for installation procedures.
If you want to upgrade the firmware on your PanelView terminal
using your computer, you must install the Serial Firmware
Upgrade Utility. For instructions on how to install this utility, see
Appendix D in the PanelView 1000e, 1200e, and 1400e Operator
Terminals User Manual.
To install PanelBuilder Version 3:
1. Start Windows 95, or 3.1 or later. If you’re already in Windows,
close all open Windows applications.
2. Insert the floppy disk in the drive.
3. If you are running on Windows 95, choose Run from the Start
button and enter a:\setup.exe, or select a:\setup.exe from
Windows Explorer.
If you are running on Windows 3.1 or later, choose Run from the
File menu. In the Run windows, type:
a:setup or b:setup
where a or b is the drive containing the PanelBuilder disk, and
press Enter.
4. Close all open Windows applications. If you have done so,
choose Next.
5. In the registration window, enter registration information about
your copy of PanelBuilder.
The serial number for your software is on the Software
Registration card that was shipped with your software.
Installing PanelBuilder
Version 3 from Floppy
Disks on Windows 95 or
Windows 3.1 or later