Rockwell Automation 2711E-ND1 PanelBuilder 1400E Configurator Software Getting Started - Manual (Page 60)

4–3 Introduction to the Tutorial
Publication 2711E-818 – January 1998
You must open your existing PanelBuilder 1200 application.
To open the application:
1. Choose Open Application from the File menu, or choose
on the toolbar. The Open dialog box appears.
2. Specify the drive and directory where the tutorial is located. If
you followed the installation defaults, this will be in the
C:\AB\PB1400E\TUTORIAL directory.
Because the existing application was created using PanelBuilder
1200, it has the file type *.pbw
3. In the List Files of Type field, select *.pbw.
You’ll see two applications. The one you choose depends on your
PanelView terminal type:
•
kc-tutor.pbw—choose this if you have a keypad terminal
•
tc-tutor.pbw—choose this if you have a touch screen terminal
4. Select the appropriate application.
5. Choose OK.
A message appears, informing you that converting the application
will make it compatible with PanelView 1400e Version 1 and
later firmware.