Rockwell Automation 2711E-ND1 PanelBuilder 1400E Configurator Software Getting Started - Manual (Page 25)

2–4 Setting Up PanelBuilder 1400e
Publication 2711E-818 – January 1998
To install PanelBuilder Version 4:
1. Start Windows NT or Windows 95. If you’re already in Windows,
close all open Windows applications.
2. Insert the CD-ROM in the drive.
The CD-ROM begins to run automatically.
3. If the install does not start automatically, choose Run from the
Start button and select setup.exe from the CD-ROM drive; or
select setup.exe from Windows Explorer.
4. In the Welcome dialog box, choose Next.
5. If you are installing on Windows 95, the Select Components
dialog box appears.
The CD-ROM includes two install versions for the PanelBuilder
1400e software:
•
Version 3—This version offers you PanelBuilder 1400e for
use with Windows 3.1 or later, or Windows 95. Version 3
supports PanelView application file transfers over networks
using INTERCHANGE and WINtelligent LINX software
drivers.
•
Version 4—This version offers you PanelBuilder 1400e for
use with Windows 95 or Windows NT. Version 4 supports
PanelView application file transfers over networks using
RSLinx software drivers.
Version 4, for use with Windows 95, is recommended. If you
choose Version 3, refer to “Installing PanelBuilder 1400e Version
3 from CD-ROM on Windows 95 or Windows 3.1 or later” in this
chapter for instructions. Otherwise, continue by selecting Version
4, and then choose Next.
Installing PanelBuilder
1400e Version 4 from
CD-ROM on Windows NT
or Windows 95