Rockwell Automation 2711E-ND1 PanelBuilder 1400E Configurator Software Getting Started - Manual (Page 31)

2–10 Setting Up PanelBuilder 1400e
Publication 2711E-818 – January 1998
If you choose to install the File Transfer Utility and you want to
upload or download files over the PLC networks, you also need
to install INTERCHANGE or WINtelligent LINX software. If
you do not have this software, contact Allen-Bradley Technical
Support for assistance.
You can obtain 3.5-inch floppy disks of the software applications by
creating them from the PanelBuilder 1400e CD or by sending in the
FAX Back Form provided with the PanelBuilder 1400e software kit
(A-B Catalog Number 2711E-ND1). For instructions on how to
create floppy disks of the software from the CD, refer to the file,
Floppies.txt, in the root directory of the PanelBuilder 1400e CD.
Note that the PanelBuilder 1400e application requires nine floppy
disks, the Transfer Utility application requires two floppy disks, and
the Serial Firmware Upgrade Utility application requires two floppy
disks.
To install PanelBuilder Version 4:
1. Start Windows NT or Windows 95. If you’re already in Windows,
close all open Windows applications.
2. Insert the floppy disk in the drive.
3. Choose Run from the Start button and enter a:\setup.exe, or select
a:\setup.exe from Windows Explorer.
The installation begins.
4. Close all open Windows applications. If you have done so,
choose Next.
5. In the registration window, enter registration information about
your copy of PanelBuilder.
The serial number for your software is on the Software
Registration card that was shipped with your software.
6. The Installation Options dialog box lists the program components
you are installing and the amount of hard disk space required for
each.
Choose the components you want to install and click Continue.
Installing PanelBuilder
1400e Version 4 from
Floppy Disks on Windows
NT or Windows 95