Rockwell Automation 1794-XXXX FLEX I/O High-Density Analog Modules - Manual (Page 17)

Publication 1794-UM062A-EN-P - September 2012
Install Your FLEX I/O Module 9
Install the Module Installation of the analog module consists of:
• mounting the terminal base unit
• installing the analog module into the terminal base unit
• installing the connecting wiring to the terminal base unit
If you are installing your module into a terminal base unit that is already installed,
proceed to the section,
Mount the Analog Module on the Terminal Base Unit , on
page 13 .
Mount on a DIN Rail
Install the Terminal Base Unit
1. Remove the cover plug in the male connector of the unit to which you are
connecting this terminal base unit.
2. Check to make sure that the 16 pins in the male connector on the adjacent
device are straight and in line so that the mating female connector on this
terminal base unit will mate correctly.
Make certain that the female FlexBus connector is fully retracted into the
base unit.
ATTENTION: Do not remove or replace a terminal base unit when
power is applied. Interruption of the FlexBus can result in
unintended operation or machine motion.
1
2
3
4 6
7
7
8
9 0
45319