Rockwell Automation 1794-XXXX FLEX I/O High-Density Analog Modules - Manual (Page 19)

Publication 1794-UM062A-EN-P - September 2012
Install Your FLEX I/O Module 11
Gently push the FlexBus connector into the side of the adapter (or
proceeding terminal base) to complete the backplane connection.
For specific wiring information, refer to the installation instructions for
the module you are installing in this terminal base unit.
7. Repeat the above steps to install the next terminal base unit.
Ensure that the cover of the FlexBus connector on the last terminal base
unit is in place.
Mount on a Panel or Wall
Installation of a FLEX I/O system on a wall or panel consists of:
• laying out the drilling points on the wall or panel.
• drilling the pilot holes for the mounting screws.
• mounting the adapter mounting plate.
• installing the terminal base units and securing them to the wall or panel.
If you are installing your module into a terminal base unit that is already installed,
proceed to the section,
Mount the Analog Module on the Terminal Base Unit , on
page 13 .
0 1
2
7
3
4 6
7
8
9
45322