Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 212)

18Ć24 AutoMax Programming Executive Version 3.x
18.4.4 Deleting a Sequence
WARNING
USE OF THE ONLINE EDITING FEATURE CAN CAUSE THE CONTROLLED
PROCESS OR MACHINE TO SUDDENLY CHANGE ITS OPERATION. IT IS THE
RESPONSIBILITY OF THE USER TO DETERMINE THE POTENTIAL HAZARDS
INVOLVED. FAILURE TO OBSERVE THESE PRECAUTIONS COULD RESULT IN
BODILY INJURY.
To delete a sequence, follow the directions below.
1. Monitor the sequence that you want to delete.
2. Enter F3 followed by the Del key. The system will prompt with
Are you sure [n]?" If you enter anything other than a Y for yes,
the sequence will not be deleted. All symbols that are used by
the sequence remain in the symbol table. The 16 symbol limit
described in 18.4.2.2 is not affected by deleting a sequence.
18.4.5 Editing a Sequence
WARNING
USE OF THE ONLINE EDITING FEATURE CAN CAUSE THE CONTROLLED
PROCESS OR MACHINE TO SUDDENLY CHANGE ITS OPERATION. IT IS THE
RESPONSIBILITY OF THE USER TO DETERMINE THE POTENTIAL HAZARDS
INVOLVED. FAILURE TO OBSERVE THESE PRECAUTIONS COULD RESULT IN
BODILY INJURY.
Make certain you have read and understood the restrictions in
18.4.2.1 Ć 18.4.2.5 before proceeding. Recall that when you are
editing a sequence while in the PC Monitor, the procedure will be
essentially the same as it is when you are creating the task in the
offline PC Editor described in 4.22.2 Ć 4.22.5, with the exceptions
described in 18.4.1.
To edit a sequence, follow the directions below.
1. Monitor the sequence you want to edit.
2. Enter F3 followed by C" for Change.
3. For help in editing the sequence, enter F1.
4. After you have finished editing the sequence, type F3 E to exit
the editor and install the edited sequence. If you change your
mind and no longer want to insert the sequence, enter F3 Q. If
you type F3 by mistake and you want to go back and edit the
sequence further, type ESC.