Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 22)

1Ć8 AutoMax Programming Executive Version 3.x
1.4.4 ASD and the Programming Executive
Systems created with the AutoMax Software Designer (ASD) V8 and
later can be converted into AutoMax Executive V3.x systems. Refer to
section 5.1.8 for instructions. See instruction manual JĆ3615 for more
information about ASD.
1.4.5 Converting from Previous Versions
Systems created with Version 2 of the AutoMax Programming
Executive software can be converted into AutoMax Executive V3.x
systems. Refer to section 5.3.8 for instructions. See instruction
manual JĆ3684 for information about Version 2 Executive software.
Systems created with earlier versions of the AutoMax Version 3
Programming Executive software can be converted into AutoMax
Executive V3.x systems. Refer to Appendix Q, Version Update Utility,
for instructions.
1.4.6 Network Communication
Note that to fully use the network communication capability of the
AutoMax Programming Executive software V3.x, all Network
Communication modules on a given network must be M/N 57C404
(or later). An earlier version of the module (M/N 57404) can be used
in the system, but the user will need to connect directly to the rack
containing the Network module in order to communicate with that
rack with a personal computer. M/N 57404 cannot be mixed with any
other version on the same network. If Network module versions on a
particular network are mixed, the communication capability of the
network will be that of the earliest version of the Network module.