Rockwell Automation 57C650 AutoMax Programming Executive Version 3.8 - Manual (Page 262)

KĆ2 AutoMax Programming Executive Version 3.x
DCS Drive Controller (M/N 57406) Example
The registers listed below are used to configure the DCS Drive Controller.
Current Version
AutoMax V2 Executive AutoMax
RegisterBit RegisterBit Function
1 4096 Analog Reference Input
2 4097 Analog Tach Feedback
3 4098 Armature Voltage Feedback
4 4099 Major Loop Current FDBK
5 4100 AC Line Voltage FDBK
41 4136 Tach Loss Delta Threshold
42 4137 PLL Max. Phase Change
43 4138 PLL Max. Period Change
51 0 4146 0 Fast Bridge Change Enable
Note that the register numbers used in the current version correspond to the old
register numbers plus 4095. Before executing the Import procedure, edit your
AutoMax V2 configuration task to set the register numbers for this module to their
new values by adding 4095 to each register number used for this module.