Rockwell Automation GV3000/SE V.6 Regulator Board 0-56921-6xx, 413338-6BU, 0-56940-6xx, 814.61.00 - Manual (Page 2)

©1998 Rockwell International Corporation
The information in this manual is subject to change without notice.
Throughout this manual, the following notes are used to alert you to safety considerations:
Important: Identifies information that is critical for successful application and understanding of the product.
!
ATTENTION: Identifies information about practices or circumstances that can lead to personal
injury or death, property damage, or economic loss.
GV3000/SE, AutoMax, and Reliance are trademarks of Rockwell Automation.
!
ATTENTION: Only qualified electrical personnel familiar with the construction and operation of
this equipment and the hazards involved should install, adjust, operate, and/or service this
equipment. Read and understand this manual and other applicable manuals in their entirety before
proceeding. Failure to observe this precaution could result in severe bodily injury or loss of life.
ATTENTION: DC bus capacitors retain hazardous voltages after input power has been
disconnected. After disconnecting input power, wait five minutes for the DC bus capacitors to
discharge and then check the voltage with a voltmeter to ensure the DC bus capacitors are
discharged before touching any internal components. Failure to observe this precaution could
result in severe bodily injury or loss of life.
ATTENTION: The user is responsible for conforming with all applicable local, national, and
international codes. Failure to observe this precaution could result in damage to, or destruction
of, the equipment.
ATTENTION: The Power Module identification procedure enabled in parameter P.998 clears the
contents of parameter P.999. Only qualified electrical personnel who understand the potential
hazards involved should make modifications to parameters P.998 and P.999. Failure to observe
this precaution could result in damage to, or destruction of, the equipment.
ATTENTION: Entering incorrect values in parameter P.999 will configure the Regulator board
incorrectly for the connected Power Module. This parameter must be set by a qualified person
who understands the significance of setting it correctly. Failure to observe this precaution could
result in damage to, or destruction of, the equipment.
ATTENTION: The drive contains printed circuit boards that are static-sensitive. An anti-static
wristband should be worn by any person who touches the drive components, connectors, or wiring.
Erratic machine operation and damage to, or destruction of, equipment can result if this precaution
is not followed.