Rockwell Automation GV3000/SE V.6 Regulator Board 0-56921-6xx, 413338-6BU, 0-56940-6xx, 814.61.00 - Manual (Page 70)

Installing Regulator Board P/N 814.61.00 in 2 to 15 Amp and 24 to 30 Amp GV3000/SE Bookshelf Drives 10-5
Step 3. Drive With Option Boards Only: Remove the Option Board from the Drive
Step 3.1. Remove the four fasteners that attach the option board to the drive.
Step 3.2. Disconnect the option board from the Regulator board by sliding the
Regulator board ribbon cable out of the connector on the option board.
Step 4. Remove the Regulator Board from the Drive
Step 4.1. Disconnect the Regulator board from the Power board by sliding the Power
Module Feedback ribbon cable out of the connector on the Regulator
board.
Step 4.2. Remove the two screws that attach the Regulator board to the drive.
Step 4.3. The Regulator board is held in place by two plastic posts. Use a pair of
needle-nosed pliers to pinch the posts. Slide the board off the posts.
Figure 10.3 – 24 to 30 Amp GV3000/SE Bookshelf Drive (Cover and Front Panel Removed)
!
ATTENTION: The drive contains printed circuit boards that are
static-sensitive. An anti-static wristband should be worn by any person
who touches the drive components, connectors, or wiring. Erratic
machine operation and damage to, or destruction of, equipment can
result if this precaution is not followed.
AC Input Power
Terminals
(L1, L2, L3)
DC Bus
Measuring Points
(–)45, (+)47
Keypad/Display
Cable Connector
Power Module
Feedback
Regulator Board
Ribbon Cable
Regulator
Board
Connector