Rockwell Automation GV3000/SE V.6 Regulator Board 0-56921-6xx, 413338-6BU, 0-56940-6xx, 814.61.00 - Manual (Page 9)

Locating the Appropriate Installation Procedure 1-1
C
HAPTER
1
Locating the Appropriate
Installation Procedure
This manual provides instructions for replacing the Regulator board in your installation
with a GV3000/SE version 6 Regulator board. It is intended for qualified electrical
personnel responsible for installing and programming the GV3000/SE drive.
The installation procedure consists of:
• Replacing the Regulator board
• Identifying the Power Module to the Regulator board
• Restoring your configuration
Perform the installation procedure in the order in which it is presented in this manual.
The procedure differs depending on the drive type. Use table 1.1, 1.2, or 1.3 to locate
the appropriate installation procedure in this manual.
If your drive’s model number is not listed in table 1.1, 1.2, or 1.3, the regulator software
might not be compatible with your drive. Contact Reliance Renewal Parts for a
compatible Regulator board.
Important: If you are replacing the Regulator board to upgrade your system to
version 6, and you have purchased the Control and Configuration
Software (CS3000), save your configuration to a personal computer
before you begin the installation procedure if you have not done this
previously. Refer to the CS3000 instruction manual (D2-3348) for this
procedure.
Refer to the GV3000/SE drive hardware manual if the drive installation must be in
compliance with the European Community Electromagnetic Compatibility Standards.
Tables 1.1, 1.2, and 1.3 list the appropriate manuals for each model number.
1.1 Getting Assistance from Reliance Electric
If you have any questions or problems with the products described in this instruction
manual, contact your local Reliance Electric sales office. For technical assistance, call
1-800-726-8112.