Rockwell Automation GV3000/SE V.6 Regulator Board 0-56921-6xx, 413338-6BU, 0-56940-6xx, 814.61.00 - Manual (Page 27)

Installing Regulator Board P/N 0-56921-6xx in 1 to 20 HP @ 230 VAC Drives 4-1
C
HAPTER
4
Installing Regulator Board
P/N 0-56921-6xx in
1 to 20 HP @ 230 VAC Drives
Use the procedure in this chapter to replace the Regulator board (P/N 0-56921-6xx) in
1 to 20 HP@230 VAC GV3000/SE drives with the model numbers listed in table 4.1.
If the drive is panel-mounted, this procedure will be easier to perform if the drive is
removed from the panel.
Some steps are only required if an option board, such as the AutoMax Network option
board, is installed. These steps are preceded by the text “Option board only.”
!
ATTENTION: Only qualified electrical personnel familiar with the
construction and operation of this equipment and the hazards involved
should install, adjust, operate, and/or service this equipment. Read and
understand this manual and other applicable manuals in their entirety
before proceeding. Failure to observe this precaution could result in
severe bodily injury or loss of life.
ATTENTION: The drive is at line voltage when connected to incoming
AC power. Disconnect, lock out, and tag all incoming power to the drive
before performing the following procedure. Failure to observe this
precaution could result in severe bodily injury or loss of life.
ATTENTION: DC bus capacitors retain hazardous voltages after input
power has been disconnected. After disconnecting input power, wait five
minutes for the DC bus capacitors to discharge and then check the
voltage with a voltmeter to ensure the DC bus capacitors are discharged
before touching any internal components. Failure to observe this
precaution could result in severe bodily injury or loss of life.
Table 4.1 – Model Numbers for 1 to 20 HP @ 230 VAC Drives
1V21xx
1V24xx 7V21xx
7V22xx
2V21xx
2V24xx 10V21xx
10V22xx
3V21xx
3V24xx 15V21xx
15V22xx
5V21xx
5V24xx 20V21xx
20V22xx