Rockwell Automation SA3100 Diag,Troublesht,Startup,Guide - Manual (Page 13)

Introduction 1-5
1.2 Typographical Conventions
The following typographical conventions are used in this manual:
• Variable names
Variables names are shown in all capital letters followed by the appropriate
terminating character. The variable names shown in this manual are suggested
names only and may vary from the names used in your application.
Example: MCR@
• Register names
Register names are shown with the initial letters capitalized followed by the
corresponding register number for both drive A and drive B. The drive A register
number is shown first followed by the drive B register number (A/B).
Example: Drive Fault register (202/1202)
• Bit names
Individual bit names are shown with the initial letters capitalized. Also shown, in
parentheses, is the bit’s register number, bit number, and suggested variable name.
Example: Fault Reset bit (register 100/1100, bit 8, FLT_RST@ )
• Parameter entry screen titles
Parameter entry screen titles and the parameters themselves are shown with the
initial letters capitalized.
Example: Feedback Data parameter entry screen