Rockwell Automation SA3100 Diag,Troublesht,Startup,Guide - Manual (Page 33)

Installation and Start-Up Guidelines 4-1
C
HAPTER
4
Installation and Start-Up
Guidelines
This section describes general guidelines that should be followed when verifying the
correct installation of the drive hardware and in performing the drive start-up. For more
information regarding installation guidelines, refer to instruction manual D2-3115
(Installing, Operating, and Maintaining Engineered Drive Systems).
As part of the start-up procedure, the AutoMax Programming Executive software is
used to verify the status of drive I/O and to make drive adjustments. Section 4.1
describes some of the restrictions imposed by the AutoMax Programming Executive
software.
4.1 Using the AutoMax Programming Executive to
Access the Rack
The AutoMax Programming Executive enables four users to access and work in the
same rack simultaneously. However, certain restrictions exist when more than one
user is working in a rack.
• The maximum number of users is four (4) per rack (one user connected directly to
the rack and three users connected via the DCS/AutoMax Network, or four users
connected via the DCS/AutoMax Network).
• Data access is required for the user to Set/Force COMMON variables. All users
must assure that variable values are not written over by other users working in the
rack.
• Task access is required for the user to load a single task and to Set/Tune/Force
LOCAL variables in a task. Only one user will be granted Task access for each task
in the rack.
• Rack access is required to load the rack configuration and to load all application
tasks (AutoMax tasks and UDC tasks).
!
ATTENTION:Only qualified personnel familiar with the construction and
operation of this equipment and the hazards involved should install,
adjust, operate, or service this equipment. Read and understand this
manual and other applicable manuals in their entirety before proceeding.
Failure to observe this precaution could result in severe bodily injury or
loss of life.
ATTENTION:The user is responsible for conforming with all applicable
local, national, and international codes. Failure to observe this precaution
could result in damage to, or destruction of, the equipment.