Index, Ndex – Rockwell Automation SA3100 Diag,Troublesht,Startup,Guide User Manual
Page 83
Index
Index-1
I
NDEX
A
Accessing the AutoMax rack, 4-1 to 4-2
AutoMax programming executive
access levels, H-1
AutoMax rack
status of data, G-1
B
Basic drive interconnections, 4-3 to 4-4
Bridge test mode, 3-4 to 3-7
bridge test connections, 3-5
power device test locations, 3-6
C
Checking installation with power off, 4-6
D
DC bus monitoring
during bridge test mode, 2-7
during torque minor loop mode, 2-7
DC bus supply, 4-9
Definition of terms, 2-1
Diagnostic fault code register, D-1 to D-3
Diagnostics and troubleshooting, 2-1 to 2-7
Drive fault, 2-4 to 2-6
clearing, 2-6
how the system reacts, 2-4 to 2-5
Drive fault register, A-1 to A-4
Drive inspection and start-up guidelines, 4-4 to 4-18
checking installation with power off, 4-6 to 4-7
checking the DC bus supply, 4-9
dynamic motor tests, 4-17
feedback registers and bits, 4-14 to 4-15
Flex I/O registers, 4-11 to 4-12
I/O verification, 4-10 to 4-16
physically inspecting the drive, 4-6
physically inspecting the motor, 4-6
PMI regulator meter ports, 4-16
recommended start-up sequence, 4-4
testing AC Power Modules with power on, 4-8
testing DC Power Modules with power on, 4-9
UDC module meter ports, 4-15
UDC module test switch register, 4-15
UDC/PMI communication status, 4-10
uncoupled motor tests, 4-16 to 4-17
updating drawings and software listings, 4-18
Drive warning, 2-6
clearing, 2-6
Drive warning register, B-1 to B-4
Dynamic motor tests, 4-17
E
Environmental requirements, 4-2
F
Feedback registers and bits, 4-14 to 4-15
Flex I/O, 4-11 to 4-12
analog data formats, 4-13
digital data formats, 4-12
register formats, 4-11
I
I/O verification, 4-10
Idle mode, 3-4
Installation and start-up guidelines, 4-1 to 4-18
Installing the drive, 4-3