SARGENT Passport 1000 PG Exit Devices - Manual (Page 12)

Modular
component
Fig. 6A
Rim Installation Instructions (Continued)
6A – Installation of Inside
Component Assembly
1. Insert bottom of component assembly first (Fig. 6A).
2. Clip top of component assembly to mounting plate
verifying both tabs attached securely.
Secure the following connectors onto the circuit board (Fig. 6B1 and 6B2):
1. Secure the mortise lock body assembly connector (10-pin).
2. Secure the mortise keypad/card reader connector (14-pin).
3. Secure the LCU connector (7-pin).
NOTE:
• Connectors go on only one way.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
Inside of door
From ET Control
From Outside Trim (LCU
Card Reader)
From Outside Trim
(Keypad)
From Outside Trim
(ground)
Fig. 6B2
(Detail)
Fig. 6B1
Detail
6B - Installation of Connectors
10/31/12
A7809B 12
Copyright © 2012, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Passport 1000 PG Exit Device